3.4u Isometric Drawing
The CSWIP exam gives you the drawing. You have one hour to convert it to isometric. I teach you how, step by step. Levels 1 to 3 are free.
Start free
Levels 1 to 3 are free
The first 11 lessons: pencil basics, circles and pipes. Watch them, draw them, check them.
Start the free preview See the course, $14927 video lessons. 12 months access. 30 day money back.
What you will learn
Short video lessons that build one skill at a time. Watch it, try it on paper, then check it.
The basics
The three isometric directions, boxes, cubes, and circles drawn freehand and with a compass.
Pipes and joints
Pipes, cones, the curve where a stub meets a pipe, and angled braces drawn without copying the plan angle.
Flanges and clamps
Reading the drawing, sizing in proportion, bolts on a bolt circle, flanges on a pipeline and clamps.
The exam hour
Worked nodes and clamps, a one-hour plan, timed practice drawings and a checklist to mark yourself.
A personal note
This section is harder than it sounds. I know, because I had to redo it.
I knew every node, clamp and flange from the water. What I didn't have was a method for getting them onto paper, in the right directions, inside an hour.
So I took the time to teach it properly. One skill at a time, in the order I wish I'd learned it, using the components you already work on.
Sean
Inspection Diver, more than 25 years offshore. CSWIP 3.4u and 3.2u.
Draw it right in the exam hour
Start with the 11 free lessons before you spend anything.
Start the free preview